Block and Report Sequencing

You must run some UBEs in a specific sequence. For example, you must run the UBE for block 0 prior to running UBEs for any other blocks, so you must set the sequence number for the UBE for block 0 at a lower sequence number than for other UBEs. Similarly, you must run the UBE for block 9 after you run the UBEs for all other blocks, including any custom programs that you need to run.

Note:

If you ran the Initial Setup - UBEs by Block and Required Registers program to populate the SPED Records Rules table (F76B930), the program also populated the Ato Cotepe Detail Blocks Template table (F76B0731) with the program IDs, versions, and sequence. You only modify this information if you have customer programs to add.

See Adding and Maintaining Register Requirements for SPED Bookkeeping Types

This table shows how the Initial Setup - UBEs by Block and Required Registers program populates the F76B731 table for SPED accounting (Ato Cotepe Version is SD).

Block	Program ID	Version	Block Sequence	Report Sequence
Block 0	R76B952	ZJDE0001	1	1
Block I	R76B954	ZJDE0001	2	1
Block I	R76B955	ZJDE0001	2	2
Block I	R76B960	ZJDE0001	2	3
Block I	R76B965	ZJDE0001	2	4
Block I	R76B970	ZJDE0001	2	5
Block I	R76B960	ZJDE0002	2	6
Block I	R76B950	ZJDE0001	2	7
Block J	R76B985	ZJDE0001	3	1
Block J	R76B990	ZJDE0001	3	1
Block 9	R76B995	ZJDE0001	4	1

Important: If you use custom programs to report data, add the custom programs in the appropriate order. You must sequence the programs so that the program for block 0 runs first and the program for block 9 is the last program to run.