Results

Select the Results tab.

Blend ID Method From

Specify the method to use to calculate the blend ID of the After From lot.

Values are:

Copy after from before.

Do not default after Blend ID.

Generate new Blend ID.

Blend ID Method To

Specify the method to use to calculate the blend ID of the After To lot. The system also uses this value to copy the alternative blend ID from Before lots to After lots when you perform move operations. See Understanding Alternative Blend IDs.

Values are:

Copy after from before.

Do not default after Blend ID.

Generate new Blend ID.

Use the largest contributing lot.

Planned Operation Gain/Loss

Enter a percentage to represent the gain or loss that you anticipate as a result of the completed operation. Enter a negative percentage for a loss.

Allowed Operation Gains/Loss

Enter a percentage that the system uses as a threshold for acceptable gains or losses in material as the operation progresses. Enter a negative percentage for a loss.

Note: If you enter zero, no threshold for acceptable gains or losses exists, and the system does not generate an error message when the operational loss is less than zero percent.

Topping Loss Calculation Method

Specify the method used to record loss for topping operations. Values are:

None: This is not a topping operation.

Survey Loss: This is a topping operation.

A survey loss is assumed in the To vessel that is equal in volume to the amount of topping material that is removed from the From vessel. The topping material is then blended with the reduced volume in the To vessel. The volume of the To vessel has no net change.

Operation Loss: This is a topping operation.

All the material that was moved from the From vessel is consumed in an Operational Loss for the operation. The volume of the To vessel has no net change.

From After Material Type

Enter a specific material type for the From After lot. If this value is blank, the system uses lot blending rules to determine the From After material type.

Note: To perform a crush operation on the bulk material that you receive on a weigh tag, you must enter the material type that you set up with a unit of measure type of Weight.

To After Material Type

Enter a specific material type for the To After lot. If this value is blank, the system uses lot blending rules to determine the To After material type.

Note: For spirit operations you must specify a To After material type. Otherwise, the system issues an error when you try to use a vessel that contains a spirit for the operation.

From After Wine Status

Enter a specific wine status for the From After lot. If this value is blank, the system uses lot blending rules to determine the From After wine status.

To After Wine Status

Enter a specific wine status for the To After lot. If this value is blank, the system uses lot blending rules to determine the To After wine status.