Entering Branch/Plant Manufacturing Information
Access the Additional System Info. form.
For each item, you can define manufacturing information that is specific to each branch/plant, including:
Type of information |
Description |
|---|---|
Requirements planning information |
Enter information about inventory shrinkage in order to plan for the quantity that you need to replace due to shrinkage. |
Leadtime information |
Enter leadtime information to calculate the time frames that are necessary to assemble or manufacture an item. |
Engineering information |
Enter reference information about the drawing plans for items. |
Most of the items on Plant Manufacturing Data tab are identical to those on Manufacturing Data. The system uses the default values that you specified on Manufacturing Data.
- Shrink Factor
Enter a fixed quantity or percentage that the system uses to determine inventory shrinkage for an item. If you are entering a percentage, enter 5 percent as 5.00 and 50 percent as 50.00.
The system increases the planned order quantity by this amount in MPS/MRP/DRP generation. The shrink factor method that you specify for the item determines whether the shrink factor is a percentage or a fixed quantity.
- Shrink Factor Method
Enter a value that determines whether the shrink factor that you enter for this item is a percentage or a fixed quantity. Values are:
%: Percentage of order or requested quantity.
F: Fixed amount to be added to quantity.
- Issue and Receipt
Enter a code that indicates whether an item is received at the time of inventory issues or whether the system uses the Receipt Routing Movement and Disposition program (P43250). Values are:
0: The system does not perform any actions.
1: The system receives an item when an inventory issue occurs.
2: The system uses the P43250 program when an inventory issue occurs.
- Replenishment Hours
Enter the time that is required before a consuming location has a replacement kanban available from its supplying location.
This value is used only for kanban card processing in the JD Edwards EnterpriseOne Shop Floor Management system.
- Setup Labor
Enter the standard setup hours that you expect to incur in the normal completion of this item. This value is not affected by crew size.
- Queue Hours
Enter the total hours that an order is expected to be in queue at work centers and moving between work centers.
The system stores this value in the F4102 table. You can calculate this value using the Leadtime Roll up program, or you can enter it manually. When you run the Leadtime Roll up program, the system overrides manual entries and populates the table with calculated values.
- Time Basis
Enter a code from UDC table (30/TB) that indicates how machine or labor hours are expressed for a product. Time basis codes identify the time basis or rate to be used for machine or labor hours that are entered for every routing step. Examples are 25 hours per 1,000 pieces and 15 hours per 10,000 pieces. You can maintain the time basis codes in Time Basis Codes.
The system uses the values in the Description-2 field for costing and scheduling calculations. The description is what the code represents, but is not used in calculations.
- ECO Number (engineering change order number)
Enter the number that is assigned to an engineering change order.
- ECO Reason (engineering change order reason)
Enter a code from UDC table (40/CR) that identifies the reason for the engineering change order.
- ECO Date (engineering change order date)
Enter the date of the engineering change order.
- Item Revision Level
Enter the revision level for an item. If you enter a revision level in this field, verify that the revision level of the routing for an item matches the revision level on the bill of material for the item.
- Kanban Item
Identify an item as a kanban item.