Enabling Multiple Concurrent Table Conversions
If you are planning to run your Table Conversions on the Enterprise Server, you must set
specific values in the JDE.INI
jde.ini
on your Enterprise Server in order to enable
multiple Table Conversions to run simultaneously.
To enable multiple concurrent table conversions:
Open the
JDE.INI
jde.ini
on your Enterprise Server using an ASCII editor compatible with the operating system.Add or update the following entries and their respective values in the
[JDEIPC]
section:[JDEIPC] maxNumberOfResources=2000 maxNumberOfSemaphores=1000
Note: The above values are sufficient to
run four Table Conversions at once. To run more, you may need to increase these
values. The symptom of the values being set too low is that the Table Conversion
will fail almost immediately on the server with this error message in its
jde.log
:If
you plan on running more than four concurrent Table Conversions, refer to the JD Edwards EnterpriseOne
Tools Runtime Administration
Guide for details on calculating
the correct values for the anticipated workload on your machine.Note: Solaris
ConsiderationBecause the setting for
maxNumberOfSemaphores=1000
, the Solaris system administrator
must change the OS kernel configuration for the semmsl
parameter so
that it has a value greater than 1000. Failure to do so will prevent you from
starting JD Edwards EnterpriseOne services on the Enterprise Server.