Configuring Nodes to Handle Segmented Messages

This section describes how to configure nodes to handle segmented messages.

Understanding Configuring Nodes to Handle Segmented Messages

Before you can send segmented messages, you must configure the remote node defined on the local system to handle segmented messages by setting the Segment Aware option on the Node Definitions page in the PeopleSoft Pure Internet Architecture.

WARNING:

Do not set the Segment Aware option for remote PeopleSoft 8.45 or earlier nodes, or for third-party systems. If you do so, the receiving system will consume only the first segment of the messages and ignore any subsequent segments.

Configuring a Node to Handle Segmented Messages

To configure a node to handle segmented messages:

1. Select PeopleTools, and then Integration Broker, and then Integration Setup, and then Node Definitions.

2. Select a node with which to work and click OK.

   The Node Definitions page appears.

3. Select the Segment Aware check box.

4. Click the Save button.