Generating Threshold Parameter Files for PeopleSoft Health Center Alerts (Logstash)

Threshold parameters are used on the Configure Health Alerts page in PeopleSoft Health Center. The OSK installation prompts you for information on configuring alerts. If you perform the OSK installation before you configure alerts for the PeopleSoft Health Center, carry out these steps to use health alerts:

In your PeopleSoft application, configure Health Center alerts.

See PeopleTools: Performance Monitor, "Configuring Health Center Alerts."
Register the PPM and JMX agents as described in an earlier section.

See Obtaining the Integration Broker REST URL.

See PeopleTools: Performance Monitor, "Configuring PeopleSoft Health Center."
Enter the value for the Integration Broker REST URL in LOGSTASH_HOME\pt\config\JsonLogstash.properties.

See "Performing Additional Tasks," Reviewing the Logstash Configuration Files.
Set the following environment variables:
- Add JAVA_HOME to the PATH environment variable, where JAVA_HOME is the installation location for Java.
  
  For Microsoft Windows:
```
PATH=%JAVA_HOME%/bin;%PATH%
```
  For Linux:
```
export PATH=JAVA_HOME/Bin;$PATH
```
- Set LOGSTASH_HOME to the installation location for Logstash if necessary.
  
  For Microsoft Windows:
```
set LOGSTASH_HOME=BASE_DIR\pt\logstash-9.1.3
```
  For Linux:
```
export LOGSTASH_HOME=BASE_DIR/pt/logstash-9.1.3
```
Go to LOGSTASH_HOME\pt\bin and run the script FetchThreshold.bat (Microsoft Windows) or FetchThreshold.sh (Linux) to generate ThresholdParams.json.

Note:

For information on generating ThresholdParams.json files with an SSL setup, see the section Using Logstash with an SSL Setup.