This image shows the Test Application tab. The Application toolbar is displayed across the top of the page and shows that the user is in Edit mode. Below the toolbar is the Application Home and the Application Test tabs. The Application Test tab is open. Located at the top left-hand corner is a drop-down list where you can choose either Current Application or Last Published Version. This image shows Current Application. To the far right is the Activate button. This button has a blue background. Below the drop-down list and Activate button are to sections displayed side by side. To the left Is the Recent Activity section and to the right is a table listing error and warning messages. The table has 3 columns. The first column contains icons indicating if the message is an error or warning. the 2nd column is titled Source and the 3rd column is titled Message/Description. This image displays no warning messages. Below these sections is a section that runs across the width of the page. Because an application has not been activated, this image displays the following information: The section title No Application activated to Test. To the right of the title are two buttons. Play and Try in Test Mode. To the far right is the Un-activate button. Buttons in this section are not active and have a grey background. Below the title the Activation Revision, Activation Date, and Status are displayed. These fields have no values and are not active. Below this information is a list of tips: Select a revision from above and activate to test, Manage your activated application from here, Play it or try it in test mode, Improve the flow and activate it again (only one active version is supported in test), Once your application is ready and tested, go to management and activate it to a local or remote environment.