Rule Sets

This page is accessed via Configuration and Administration > Power Data > General > Rule Sets.

This page enables you to copy/manage rule sets. This may help you enhance performance by allowing you to easily disable unnecessary rules. You may also re-sequence the order the rules run. Rule sets are comprised of rules.

Some public rule sets are marked as templates indicating that all relevant rules are associated with that set. You cannot create templates, only view existing ones.

Note: Rules for the Order Base and Order Release Bundling Rule Sets can be turned on and off, but any changes made to their order in the Rule Manager are ignored.

Public rule sets cannot be edited.

Note: You cannot enter lower case rule set IDs that contain an 'x'.

Copying Rule Sets

1. From the Rule Set manager or finder results page, click the Copy Rule Set button.
2. Enter a unique identifier in the Rule Set ID field.
3. Enter a Rule Set Name.
4. Enter a Domain Name or accept the default.
5. Highlight rules that should be ON in the Rules Off pane.
6. Use the right arrow buttons to set the selected rules to ON.
7. If there are rules that are on that should not be, highlight them in the On pane and use the left arrows to remove them.
8. Use the up and down arrows to determine the run sequence of the rules that are set to ON.
9. Click Finished.