Prompt-location screen flows

1. In the RF Receive by Shipment or RF Receive by Load modules, when you configure the screen parameter “prompt-location” as Do not prompt, the location prompt is not displayed after receiving is complete.
2. In the RF Receive by Shipment or RF Receive by Load modules, when the screen parameter “prompt-location” is configured as Prompt if not known, location prompt is displayed after receiving is complete. You can enter a reserve, active, or dock location or skip entering any location by using Ctrl+W or Ctrl+X.
   1. Location prompt is not displayed after receiving is complete:
      1. If a dock door is scanned at the beginning of receiving. Instead the LPN will be located to the scanned dock door.
      2. If the shipment/load is associated to an appointment that has been checked into a dock. Instead the LPN will be located to the dock door where the shipment/load was checked in through appointment.
      3. If the screen parameter “next-screen-to-launch” is configured as rf.inbound.cwrfibsortlpn (Inbound Sorting).
      4. If cross dock is enabled in the receiving module, and cross dock completes successfully.
   2. After receiving an LPN, if the QC Status of LPN is Marked for QC, then location display is driven by the screen parameter “qc-handling-mode”.
      1. If the screen parameter “qc-handling-mode” is configured as Mark for QC prompt QC locn, the QC location prompt is displayed.
      2. If the screen parameter “qc-handling-mode” is configured as Mark for QC do not prompt QC locn, the location prompt is not displayed.
   3. If you enter an active location, the system throws the error “Cannot putaway to location type A” if:
      1. Flow through allocation (MHE) is enabled and flow through allocation is successful.
      2. You have received Pallet through “Palletize Upfront” or “Palletize after receipt” or “LPN or Pallet receiving.”

In the above two scenarios, you only have the option to enter a Reserve or Dock location.