Control Recount Prompt During Mobile Cycle Count Location and Cycle Count LPN Transactions

When performing Mobile Cycle Count Location (rf.inbound.cwrfcyclecountlocn) and Cycle Count LPN (rf.inbound.cwrfcyclecountiblpn transactions, you can control the recount prompt when inventory discrepancy is detected.

In immediate mode, the system immediately updates the counted inventory. In deferred mode, the system records discrepancy counts on the Cycle Count Adjustments UI, where you can verify or reject the counts for recounts. Sometimes, it may be counterproductive.

To control the recount prompt during transactions, you can use the screen parameter “allow_recount” in the Mobile Cycle Count Location and Cycle Count LPN transactions. This allows you to avoid unnecessary recount prompts.

The behavior of this screen parameter is outlined in the following table:

Screen Parameter Configuration	Behavior
allow_recount = Yes or Blank	Default behavior: During the transaction, if any quantity, inventory, or LPN discrepancy occurs in cycle count, the system prompts for recount. Also, the system displays an info message to notify the discrepancy.
allow_recount = No	The system does not prompt for a recount. The system displays only an info message to notify the discrepancy.

Note: In immediate mode, the system updates inventory changes on completing cycle counts. In this case, it is advisable to enable the recount prompt when a discrepancy occurs. This way, you are aware of the discrepancy and can perform recount.