Running Jobs

On the Run Jobs page, you can run any job that has been previously configured. Before running a job, you may want to estimate its duration. See Estimating Comparison Time.

1. Click Run Jobs in the navigation pane.

2. Select a job from the drop-down.

3. Select a profile from the drop-down.

4. Select the Run Repair Automatically after Compare, if you want to run repair automatically after the compare job is completed.

5. Click Expand All, to expand the Compare Pairs list and to reset any parameters.

6. Click Run Job.

To reset the Compare Pair Parameters:

Click Expand All, to expand the Compare Pairs list.

The following information is displayed in the Compare Pairs list. This information can help you to refine the job configuration.

• Row Partitions: Enables you to configure or override manual row partitions.

• Compare Pair Name: The name of the compare pair. To view actual object names, hover the mouse over the name.

• Delta Base Time: Shows the end time of the previous comparison, which provides a start time on which to base delta processing for the next run.

  Note: You have to enable delta processing option in the Groups and Compare Pairs page.

  1. To override the selected Delta Base Time, click Delta Base Time.

  2. On the Delta Base Time Selection page that opens, select the required Delta Base Time.

  3. Click Save.

• Source Table: The source table selected while generating the compare pair.

• Target Table: The target table selected while generating the compare pair.

• Overriding Manual Row Partitions