At this stage, you are ready to run Oracle Universal Installer at the command line, specifying the response file you created, to perform the installation.
On Windows, open the command prompt with Administrator privileges. The Oracle Universal Installer executable,
setup.exe, provides several options. For help information about the full set of these options, run
setup.exe with the
-help option, for example:
A new command window with the "Preparing to launch..." message appears.
To run Oracle Universal Installer, and specify a response file:
- Place the response file on the computer where you want to install Oracle Database.
- At a command prompt, run Oracle Universal Installer with the appropriate response file. On Windows, you must open command prompt with the Administrator privileges. For example:
setup.exe_locationsetup [-silent] "variable=setting" [-nowelcome] [-noconfig] [-nowait] -responseFile filename
filename: Identifies the full path of the response file.
setup.exe_location: Indicates the location of
-silent: Runs Oracle Universal Installer in silent mode and suppresses the Welcome window.
"refers to a variable within the response file that you may prefer to run at the command line rather than set in the response file. Enclose the variable and its setting in quotes.
-nowait: Closes the console window when the silent installation completes.
If you save a response file during a silent installation, then Oracle Universal Installer saves the variable values that were specified in the original source response file into the new response file.