Manual IP Address Configuration Example

If you choose not to use GNS, then before installation you must configure public, virtual, and private IP addresses.

Check that the default gateway can be accessed by a ping command. To find the default gateway, use the route command, as described in your operating system's help utility.

For example, with a two-node cluster where each node has one public and one private interface, and you have defined a SCAN domain address to resolve on your DNS to one of three IP addresses, you might have the configuration shown in the following table for your network interfaces:

Table 5-2 Manual Network Configuration Example

Identity Home Node Host Node Given Name Type Address Address Assigned By Resolved By

Node 1 Public

Node 1

node1

node1

public

192.0.2.101

Fixed

DNS

Node 1 VIP

Node 1

Selected by Oracle Clusterware

node1-vip

virtual

192.0.2.104

Fixed

DNS and hosts file

Node 1 Private

Node 1

node1

node1-priv

private

192.168.0.1

Fixed

DNS and hosts file, or none

Node 2 Public

Node 2

node2

node2

public

192.0.2.102

Fixed

DNS

Node 2 VIP

Node 2

Selected by Oracle Clusterware

node2-vip

virtual

192.0.2.105

Fixed

DNS and hosts file

Node 2 Private

Node 2

node2

node2-priv

private

192.168.0.2

Fixed

DNS and hosts file, or none

SCAN VIP 1

none

Selected by Oracle Clusterware

mycluster-scan

virtual

192.0.2.201

Fixed

DNS

SCAN VIP 2

none

Selected by Oracle Clusterware

mycluster-scan

virtual

192.0.2.202

Fixed

DNS

SCAN VIP 3

none

Selected by Oracle Clusterware

mycluster-scan

virtual

192.0.2.203

Fixed

DNS

You do not need to provide a private name for the interconnect. If you want name resolution for the interconnect, then you can configure private IP names in the hosts file or the DNS. However, Oracle Clusterware assigns interconnect addresses on the interface defined during installation as the private interface (eth1, for example), and to the subnet used for the private subnet.

The addresses to which the SCAN resolves are assigned by Oracle Clusterware, so they are not fixed to a particular node. To enable VIP failover, the configuration shown in the preceding table defines the SCAN addresses and the public and VIP addresses of both nodes on the same subnet, 192.0.2.0/24.

Note:

All host names must conform to the RFC–952 standard, which permits alphanumeric characters, but does not allow underscores ("_").