2.93 DB_LOST_WRITE_PROTECT

DB_LOST_WRITE_PROTECT enables or disables lost write detection.

Property	Description
Parameter type	String
Syntax	DB_LOST_WRITE_PROTECT = { AUTO | TYPICAL | FULL | NONE }
Default value	AUTO
Modifiable	ALTER SYSTEM
Modifiable in a PDB	No
Basic	No
Oracle RAC	In Oracle RAC instances, this parameter value is system-wide.

A data block lost write occurs when an I/O subsystem acknowledges the completion of the block write, while in fact the write did not occur in the persistent storage.

Values:

• AUTO

  When this parameter is set to AUTO on a primary database, the instance automatically decides whether it logs buffer cache reads in the redo log or not, depending on the status of the standby databases. Specifically, the primary database only logs buffer cache reads if physical standby databases with real time redo apply exist.

  When this parameter is set to AUTO on a standby database, the instance will automatically decide whether it incurs additional performance overhead to perform lost write detection or not, depending on whether apply is keeping up. If apply lag is beyond the reasonable threshold, the standby database will skip lost write protection temporarily until redo apply catches up with primary again, to ensure the lowest Data Guard role transition timings.

  The reasonable threshold is determined as follows:

  • If Fast Start Failover (FSFO) is configured through Data Guard Broker, based on apply lag threshold, then the threshold is the lesser of 60 seconds and two-thirds of the FSFO apply lag threshold.

  • Otherwise, the threshold is 60 seconds.

• TYPICAL

  When this parameter is set to TYPICAL on a primary database, the instance logs buffer cache reads for read/write tablespaces in the redo log, which is necessary for detection of lost writes.

  When this parameter is set to TYPICAL on a standby database, or on a primary database during media recovery, the instance performs lost write detection, regardless of higher redo apply lags that may impact Data Guard role transition timings.

• FULL

  When this parameter is set to FULL on a primary database, the instance logs reads for read-only tablespaces and read/write tablespaces.

  When this parameter is set to FULL on a standby database, or on a primary database during media recovery, the instance performs lost write detection.

• NONE

  When this parameter is set to NONE on either a primary database or a standby database, no lost write detection functionality is enabled.