18.2 Creating Property Graphs Using Options

Learn about the different options for graph optimization and for handling edges with missing vertices.

Using the OPTIONS clause in the CREATE PROPERTY GRAPH statement, you can specify any of the options explained in the following sections:

Using Graph Optimization Options

You can load a graph for querying and analytics or for performing update operations. Depending on your requirement, you can optimize the read or update performance using the OPTIONS clause in the CREATE PROPERTY GRAPH statement.

The following table describes the valid options that are supported in the OPTIONS clause:

Table 18-1 Graph Optimization Options

OPTIONS	Description
OPTIMIZED_FOR_READ	This can be used for read-intensive scenarios.
OPTIMIZED_FOR_UPDATES	This is the default option and can be used for fast updates.
SYNCHRONIZABLE	This assures that the graph can be synchronized via Flashback Technology. However, exceptions are thrown if one of the edge keys is either composite or non-numeric. In these cases, the graph can normally still be loaded, but PGX generates a new (numeric and non-composite) edge key. Such edges can therefore not be synchronized with the database.

For example, the following graph is set using OPTIMIZED_FOR_UPDATES and SYNCHRONIZABLE options:

CREATE PROPERTY GRAPH hr 
VERTEX TABLES ( 
employees LABEL employee, departments LABEL department 
) 
EDGE TABLES ( 
departments AS managed_by 
SOURCE KEY ( department_id ) REFERENCES departments (department_id)
DESTINATION employees 
NO PROPERTIES 
) OPTIONS (OPTIMIZED_FOR_UPDATES, SYNCHRONIZABLE)

Note:

• SYNCHRONIZABLE option can be used in combination with OPTIMIZED_FOR_UPDATES and OPTIMIZED_FOR_READ. But, OPTIMIZED_FOR_UPDATES and OPTIMIZED_FOR_READ cannot be used together and in such a case an exception will be thrown.
• If you are creating a synchronizable graph, then ensure that the vertex and edge keys are numeric and non-composite.

Using Options to Handle Edges with Missing Vertices

If either the source or destination vertex or both are missing for an edge, then you can configure one of the following values in the OPTIONS clause in the CREATE PROPERTY GRAPH statement:

• IGNORE EDGE ON MISSING VERTEX: Specifies that the edge for a missing vertex must be ignored.
• IGNORE EDGE AND LOG ON MISSING VERTEX: Specifies that the edge for a missing vertex must be ignored and all ignored edges must be logged.
• IGNORE EDGE AND LOG ONCE ON MISSING VERTEX: Specifies that the edge for a missing vertex must be ignored and only the first ignored edge must be logged.
• ERROR ON MISSING VERTEX (default): Specifies that an error must be thrown for edges with missing vertices.

For example, the following graph is set using ERROR ON MISSING VERTEX option:

CREATE PROPERTY GRAPH region_graph 
VERTEX TABLES ( 
regions KEY (region_id), 
countries KEY (country_id)
) 
EDGE TABLES ( 
countries AS countries_regions 
SOURCE KEY ( country_id ) REFERENCES countries(country_id) 
DESTINATION KEY (region_id) REFERENCES regions(region_id) 
NO PROPERTIES 
) OPTIONS ( ERROR ON MISSING VERTEX)

On execution, the following error response is shown:

unknown vertex ID received in destination 4 of edge 5

When using IGNORE EDGE AND LOG ON MISSING VERTEX or IGNORE EDGE AND LOG ONCE ON MISSING VERTEX option, you must update the default Logback configuration file in /etc/oracle/graph/logback.xml and the graph server (PGX) logger configuration file in /etc/oracle/graph/logback-server.xml to log the DEBUG logs. Only then you can view the ignored edges in /var/opt/log/pgx-server.log file.