8.9.1 Manual Dynamic Deployment

Both Tuxedo application packages and Tuxedo machines can be added to an active domain manually.

To deploy a package manually, click Save & Deploy on the Controls panel when there are new added packages to the domain (identified by an asterisk ‘*’).

Once the Save & Deploy button is clicked, the current domain editing status is saved and a full validation is started on the domain UBBCONFIG. If the validation fails, the deployment process is stopped and an error message appears.

Note:

The UBBCONFIG entries added manually by clicking Add… cannot be deployed and activated dynamically. Dynamic deployment only works on UBBCONFIG entries imported from application packages. To make the manually added UBBCONFIG entries active, a full deployment of the domain must be performed.

To deploy a machine manually, do the following steps:

1. Click the plus ‘+’ in the Machine List panel to add a machine.

   The newly-added machine is identified with asterisk (*) at the beginning of each imported UBBCONFIG entry.

2. Configure the new machine in the UBBCONFIG section editor, if needed.
3. Click Save & Deploy in the Controls panel.

The deployment takes place immediately using the collected machine credentials and adds the new machine to the domain as a slave machine.

Note:

The machine-level dynamic deployment supports domains in MP mode only.