Table of Contents
- Title and Copyright Information
- Preface
- 1 About Oracle Private Cloud Appliance
- 2 Feature Overview
- 3 Product Accessibility
- 4 Configuration Maximums
- 5 Firmware Qualification
-
6
Known Limitations and Workarounds
-
Oracle Private Cloud Appliance Hardware
- Compute Node Boot Sequence Interrupted by LSI Bios Battery Error
- Reboot From Oracle Linux Prompt May Cause Management Node to Hang
- Oracle ZFS Storage Appliance Firmware Upgrade 8.7.20 Requires A Two-Phased Procedure
- Interruption of iSCSI Connectivity Leads to LUNs Remaining in Standby
- Emulex Fibre Channel HBAs Discover Maximum 128 LUNs
- Fibre Channel LUN Path Discovery Is Disrupted by Other Oracle VM Operations
- Poor Oracle VM Performance During Configuration of Fibre Channel LUNs
- ILOM Firmware Does Not Allow Loopback SSH Access
- Megaraid Firmware Crash Dump Is Not Available
- North-South Traffic Connectivity Fails After Restarting Network
- Some Services Require an Upgrade of Hardware Management Pack
- Compute Node USB Device Unused
- Compute Nodes Containing FC HBA With Maximum FC Paths Paths Ends Up in Dead State During Reprovisioning
- Compute Node FC HBA (Qlogic/Emulex) with FC LUNs Having Path Flapping
- Upgrade Compute Node Fails with Fibre Channel LUNs
- PCA Faultmonitor Check firewall_monitor Fails Due to nc: command not found
-
Oracle Private Cloud Appliance Software
- Do Not Install Additional Software on Appliance Components
- Node Manager Does Not Show Node Offline Status
- Compute Node State Changes Despite Active Provisioning Lock
- Compute Nodes Are Available in Oracle VM Server Pool Before Provisioning Completes
- Virtual Machines Remain in Running Status when Host Compute Node Is Reprovisioned
- Ethernet-Based System Management Nodes Have Non-Functional bond0 Network Interface
- Network Performance Is Impacted by VxLAN Encapsulation
- Altering Custom Network VLAN Tag Is Not Supported
- Configuring Uplinks with Breakout Ports Results in Port Group Named 'None'
- DPM Server Pool Policy Interrupts Synchronization of Tenant Group Settings
- Host Network Parameter Validation Is Too Permissive
- Virtual Appliances Cannot Be Imported Over a Host Network
- Customizations for ZFS Storage Appliance in multipath.conf Are Not Supported
- Customer Created LUNs Are Mapped to the Wrong Initiator Group
- Storage Head Failover Disrupts Running Virtual Machines
- Changing Multiple Component Passwords Causes Authentication Failure in Oracle VM Manager
- ILOM Password of Expansion Compute Nodes Is Not Synchronized During Provisioning
- SSH Host Key Mismatch After Management Node Failover
- External Storage Cannot Be Discovered Over Data Center Network
- Mozilla Firefox Cannot Establish Secure Connection with User Interface
- Virtual Machine with High Availability Takes Five Minutes to Restart when Failover Occurs
- CLI Command update appliance Is Deprecated
- Certain CLI Commands Fail in Single-command Mode
- Upgrader Checks Logged in Different Order
- Virtual Machine Loses IP Address Due to DHCP Timeout During High Network Load
- Adding the Virtual Machine Role to the Storage Network Causes Cluster to Lose Heartbeat Networking
- Adding Virtual Machine Role to the Management Network Causes Oracle VM Manager to Lose Contact with the Compute Nodes
- Inadvertant Reboot of Stand-by Management Node During Upgrade Suspends Upgrade
- Loading Incompatible Spine Switch Configuration Causes Storage Network Outage
- Cloud Backup Task Hangs When a ZFSSA Takeover is Performed During Backup
- Export VM to Oracle Cloud Infrastructure Job Shows as Aborted During MN Failover but it is Running in the Background
- Remove Deprecated pca-admin diagnose software Command
- Virtual Machine get Message Failed After 200 Seconds - Observed When kube clusters are Created Concurrently
- Kube Cluster Creation/Deletion Should Not Be in Progress When Management Node Upgrade is Initiated
- o2cb Service Status Reports "Registering O2CB cluster "ocfs2": Failed" State After Compute Node Provisioned
- Compute Node Upgrade Restores Default Repository When Compute Node Was Previously Not Part of Any Tenant Group or Repository
- Check of Local Repository to Ensure Target Compute Node is Empty
- Check No Physical Disks on Target Compute Node Have Repositories
-
Oracle Private Cloud Appliance Hardware
- 7 Feedback and Support