15 Servicing the Front LED Indicator Module

This section describes how to service the front LED indicator module.

The front LED indicator module is a replaceable component that requires you to power off the server before servicing. For more information about replaceable components, see Illustrated Parts Breakdown and Replaceable Components.

Caution:

Ensure that all power is removed from the server before removing or installing a front LED indicator module. You must disconnect the power cables before performing this procedure.

Caution:

These procedures require that you handle components that are sensitive to electrostatic discharge. This sensitivity can cause the component to fail. To avoid damage, ensure that you follow electrostatic discharge safety measures and antistatic practices. See Electrostatic Discharge Safety.

Remove the Front LED Indicator Module

  1. Prepare the server for service.
    1. Power off the server.
    2. Disconnect the power cords from the power supplies.
    3. Extend the server into the maintenance position.
    4. Attach an antistatic wrist strap to your wrist, and then to a metal area on the chassis.
    5. Remove the server top cover.
  2. Disconnect the LED indicator module cable from the motherboard.

    Note:

    To ease removal of the LED indicator module cable, you might need to lift the disk backplane auxiliary signal cable and SAS cable (if present) from the left-side cable trough.
    Figure showing the LED indicator module cable being disconnected from the motherboard.
  3. Remove the three No. 2 Phillips screws that secure the FIM cable cover to the chassis [1].
    Figure showing the removal of the front LED indicator module.
  4. Lift up and remove the FIM cable cover from the FIM cable cover slot [1].

    Set aside the FIM cable cover.

  5. Remove the front LED indicator module [2].
    1. Remove the two No. 2 Phillips screws that secure the LED indicator module to the server front panel.
    2. Remove the LED indicator module and cable from the server front panel.

      Remove the LED indicator module cable by carefully pulling the cable through the left-side cable trough.

Install the Front LED Indicator Module

  1. Install the front LED indicator module.
    1. Push the LED indicator module and cable through the LED housing on the server front panel [1].
      Figure showing the installation of the front LED indicator module.
    2. Install the LED indicator module cable by carefully pulling the cable through the left-side cable trough.

      Note:

      To ease installation of the LED indicator module cable, you might need to lift the disk backplane auxiliary signal cable and SAS cable (if present) from the left-side cable trough.
    3. Insert and tighten the two No. 2 Phillips screws to secure the LED indicator module to the server front panel [1].
    4. Install the FIM cable cover to the chassis by inserting it into the FIM cable cover slot [2].
    5. Install the three No. 2 Phillips screws to secure the FIM cable cover to the chassis [2].
  2. Reconnect the LED indicator module cable to the motherboard.
    Figure showing the LED indicator module cable being reconnected to the motherboard.
  3. Return the server to operation.
    1. Install the server top cover.
    2. Return the server to the normal rack position.
    3. Reconnect the power cords to the power supplies, and power on the server.
    4. Verify that the power supply AC OK LED is lit.