Installing the OKV Client Software

Each node of the Recovery Appliance needs to have the appropriate client software for the Oracle Key Vault (OKV). This is accomplished using RACLI in one step.

If the user is not an admin_user or root user who have access to /radump, then stage the okvclient.jar file in /tmp on both nodes.

1. From the primary node of Recovery Appliance, run only once the following command. It adds all OKV endpoints associated with the Recovery Appliance. It applies to ~all~ nodes.

   [root@myComputeNodeX ~]# racli install okv_endpoint
   
   Wed August 23 20:14:40 2018: Start: Install OKV End Point [node01]
   Wed August 23 20:14:43 2018: End: Install OKV End Point [node01]
   Wed August 23 20:14:43 2018: Start: Install OKV End Point [node02]
   Wed August 23 20:14:45 2018: End: Install OKV End Point [node02]

   For details on the command options, refer to “racli install okv_endpoint”.

2. Verify that the Oracle Key Vault endpoint software has been provisioned properly.

   [root@myComputeNodeX ~]# racli status okv_endpoint
   
   Node: node02
   Endpoint: Online
   Node: node01
   Endpoint: Online

All nodes should have the client software for the OKV.