OCI-16887
failed to import Oracle Data Guard broker configuration file
Cause
A failure was encountered while the broker was importing the configuration file specified by the user.
Fast-start failover was not initiated, even though a condition warranting failover was discovered, because it was enabled in observe-only mode.
Action
Ensure that the specified file exists, the proper permissions are granted, and the file has valid Oracle Data Guard broker configuration information.
In this mode, the observer will only indicate that a fast-start failover would have been initiated. If a fast-start failover is desired, disable fast-start failover to exit the observe-only mode and then re-enable it using the DGMGRL CLI DISABLE FAST_START FAILOVER and ENABLE FAST_START FAILOVER commands.
OCI-16887
failed to import Oracle Data Guard broker configuration file
Cause
A failure was encountered while the broker was importing the configuration file specified by the user.
Fast-start failover was not initiated, even though a condition warranting failover was discovered, because it was enabled in observe-only mode.
Action
Ensure that the specified file exists, the proper permissions are granted, and the file has valid Oracle Data Guard broker configuration information.
In this mode, the observer will only indicate that a fast-start failover would have been initiated. If a fast-start failover is desired, disable fast-start failover to exit the observe-only mode and then re-enable it using the DGMGRL CLI DISABLE FAST_START FAILOVER and ENABLE FAST_START FAILOVER commands.
OCI-16887
failed to import Oracle Data Guard broker configuration file
Cause
A failure was encountered while the broker was importing the configuration file specified by the user.
Fast-start failover was not initiated, even though a condition warranting failover was discovered, because it was enabled in observe-only mode.
Action
Ensure that the specified file exists, the proper permissions are granted, and the file has valid Oracle Data Guard broker configuration information.
In this mode, the observer will only indicate that a fast-start failover would have been initiated. If a fast-start failover is desired, disable fast-start failover to exit the observe-only mode and then re-enable it using the DGMGRL CLI DISABLE FAST_START FAILOVER and ENABLE FAST_START FAILOVER commands.
