Network Management Cabling Procedure

To connect Ethernet cables to the network management ports:

1. Locate the Ethernet cables you plan to connect to the Acme Packet 1100.
2. Insert the RJ45 connector on the end of the Ethernet cable into one of the network management Ethernet ports. These ports are labeled NET MGT, INT, and EXT. The release tab on the RJ45 jack will click into place when you insert it properly into the port.

   Figure 3-15 Network Management Ethernet Ports

   
3. Route the cable away from the Acme Packet 1100. Make sure that the Ethernet cables are not stretched tightly or subject to extreme stress.
4. Repeat the above steps for each additional management Ethernet cable you will connect to your Acme Packet 1100.