1. Hardware Installation and Maintenance Guide
  2. System Installation
  3. Cabling the Acme Packet 6300/6350 System
  4. Alarm Port Cabling
  5. Cabling Procedure

Cabling Procedure

To connect the alarm port cable to the NIU alarm port:

  1. Locate the alarm contact cable you plan to connect to the Acme Packet 6300/6350 System.
  2. Insert the RJ45 connector on the end of the alarm port cable into the alarm port labeled Alarm. The release tab on the RJ45 jack clicks into place when you insert it properly.
    This picture shows the alarm port on the rear of the chassis.

    Alarm Port

    Lead the alarm cable neatly away from the rear panel toward any alarm monitoring equipment. The following figure shows a Acme Packet 6300/6350 with an alarm cable properly connected.

    This picture shows the alarm port cable properly connected.

    Connected Alarm Port Cable