To connect network 10GbE optical cabling to the 10GbE
optical physical interface cards:
Locate the 10GbE
fiber optic cables you plan to connect to the
Acme Packet 6300/6350.
Insert the duplex
LC connector on the end of the fiber cable into one of the SFP+ optical
transceivers. The connector should click and lock in place when you insert it
properly. The media and signaling ports (from left to right, bottom to top) are
labeled: P0 & P1 on each NIU. The image below shows Multi Mode cable.
SFP+ Ports
Route the cable
away from the
Acme Packet 6300/6350.
Make sure that the fiber optic cables are not stretched tightly or subjected to
extreme stress. The image below shows an
Acme Packet 6300/6350
with media network cables properly connected and inserted into ports P0 &
P1. The image below shows Single Mode cable.
Repeat Steps 1
through 2 for each additional fiber optic cable you connect to your
Acme Packet 6300/6350.