Removing the Acme Packet 6400 from an Equipment Rack

To remove the Acme Packet 6400 from an equipment rack:

1. Disable the two power sources to the Acme Packet 6400.
2. Remove the two AC/DC power cords from the power supplies in the back of the system. (There are no ON/OFF switches on these power supplies).
3. Remove all power cables from the Acme Packet 6400.
4. Remove and label all attached cables from their respective ports on the chassis.
5. Remove ground cable from the rear of the Acme Packet 6400. Save the hex nuts for later re-installation.
6. Pull the Acme Packet 6400 forward and out of the equipment rack.

   Note:

   The slides have a mechanical safety stop about halfway down the slide. To fully remove the chassis, you must depress the release latch points on the chassis slides.
7. Lift the Acme Packet 6400 out of the equipment rack, and move it to an ESD safe location.