lb-cfg

Use the following procedure to perform required lb-cfg configuration.

1. From superuser mode, use the following ACLI command sequence to access the 
lb-config configuration element.

   ORACLE# configure terminal
   ORACLE(configure)# session-router
   ORACLE(session-router)# lb-config
   ORACLE(lb-config)#

2. name—A name for this lb-cfg element.
3. state—Enables or disables this configuration. When enabled, the Oracle Communications Core Session Manager starts Sc interface signaling to this target SLRM.
4. address—Specifies the IP address of the SLRM to which this Oracle Communications Core Session Manager sends Sc interface traffic.
5. port—Specifies the port on the SLRM interface to which the Oracle Communications Core Session Manager sends Sc interface traffic.
6. realm—Specifies the local realm to which this Sc interface applies.