Configuring Child Signal Termination Points
To configure a child Pipe Signal Termination Point specification:
-
Create a new Pipe Signal Termination Point specification or navigate to the editor of an existing one.
See "Creating New Specifications" for more information.
-
In the Pipe Signal Termination Point Specification editor, click the Properties tab.
-
In the Capacity Unit Amount field, enter an amount for the capacity.
The value is relative to the selection in the Unit of Measure field. When you enter a value in the Capacity Unit Amount field, the Capacity Provided field is disabled. Capacity provided information is not required for child signal termination points.
-
In the Unit of Measure field, select a unit of measure relative to the Capacity Unit Amount field.
See "Creating Units of Measure" for information about creating a new Unit of Measure.
-
In the Number of Child Signals field, select the appropriate value.
For example, select 0 if this signal termination point will not have any child signal termination points. If the signal termination point will have children, this value will be greater than 0. For example, in a SONET or SDH signal structure, there can be more than two levels of signal termination points.
-
From the File menu, select Save.