4.574 rtrv-sfappopts

Use this command to retrieve the parameters from the SFAPPOPTS table.

Parameters

This command has no input parameters.

Example

rtrv-sfappopts

Dependencies

The SFAPP table should be accessible.

Output

This example shows output with default SFAPP options in Eagle Rel 46.7.0:

rtrv-sfappopts
     tekelecstp 18-09-13 01:26:30 EST  EAGLE 46.7.0.0.0-75.10.0
     rtrv-sfappopts
    Command entered at terminal #17.
;
   






Command Accepted - Processing
    tekelecstp 18-09-13 01:26:30 EST  EAGLE 46.7.0.0.0-75.10.0
    SFAPP OPTIONS TABLE
    ------------------
    VLRIMEICHALLENGE = no
    MODE             = active
    SUCCTH           = none
    FAILTH           = none
    VELTH            = none
    AGETIME          = none

Legend

  • VLRIMEICHALLENGE - Enables/Disables the VLR IMEI challenge for CAT3.2 messages
  • MODE- Provides option to turn off dynamic learning, test the learning algorithm, and move the system in operation using various modes
    • OFF- Turn off the dynamic learning. Delete all the dynamic entries
    • LEARN - Only learn about new VLRs, no challenges are performed (newly learned VLRs are considered as Whitelisted). Delete dynamic entries without parent in static when switch from ACTIVE or TEST mode
    • ACTIVE - Challenges are performed. Status of dynamically learned VLRs are changed to Whitelisted or Blacklisted if they meet criteria
    • TEST - Challenges are performed. However, learned VLRs remain Grey listed
  • SUCCTH If system-wide success threshold is 0 i.e., None, then do not transition any VLR to whitelist
  • VELTH - In case VELTH is set to None, all dynamic VLR roaming entries will always be in LEARNING phase and will never be used for VLR validation
  • AGETIME - In case agetime is set to None, ageing will not perform