Table of Contents

• Title and Copyright Information
• My Oracle Support (MOS)
• Acronyms
• What's New in This Guide
• 1 Introduction
  • 1.1 Overview
  • 1.2 Scope and Audience
  • 1.3 References
• 2 G-Flex C7 Relay (G-Flex) Feature
  • 2.1 Introduction
  • 2.2 G-Flex Feature Description
    • 2.2.1 Number Conditioning
    • 2.2.2 G-Flex Call Flows
    • 2.2.3 G-Flex Relay Function Description
      • 2.2.3.1 Conversion of National/Local Numbers to International Numbers
      • 2.2.3.2 Conversion of E.214 MGT to E.212 IMSI
      • 2.2.3.3 RTDB Lookup
      • 2.2.3.4 Message Forwarding
    • 2.2.4 MTP-Routed SCCP Message Processing
    • 2.2.5 G-Flex Configuration Options
    • 2.2.6 DigitAction Expansion
    • 2.2.7 G-Flex SCCP Service Re-Route Capability
      • 2.2.7.1 G-Flex Re-Route Message Handling
    • 2.2.8 G-Flex in an ANSI Environment
    • 2.2.9 G-Flex as a "Stand-Alone" Node
    • 2.2.10 Assumptions/Limitations
  • 2.3 Hardware Requirements
  • 2.4 MPS/EPAP Platform
• 3 G-Flex MAP Layer Routing (G-Flex MLR) Feature
  • 3.1 G-Flex MAP Layer Routing
  • 3.2 Limitations
• 4 EAGLE Commands
  • 4.1 EAGLE Commands
• 5 G-Flex Feature Configuration
  • 5.1 Introduction
    • 5.1.1 EPAP Provisioning Blocklist
    • 5.1.2 EPAP Entity Provisioning
    • 5.1.3 System Prerequisites
    • 5.1.4 G-Flex Feature Prerequisites
    • 5.1.5 G-Flex MAP Layer Routing Feature Prerequisites
  • 5.2 G-Flex and G-Flex MLR Configuration Procedure
  • 5.3 Configure the System for HLR Destinations
  • 5.4 Enable and Turn on the G-Flex Feature
  • 5.5 Provision STPOPTS Options for G-Flex
  • 5.6 Provisioning the G-Flex Service Selector
    • 5.6.1 Adding a G-Flex Service Selector
    • 5.6.2 Removing a Service Selector
    • 5.6.3 Changing an Existing Service Selector to a G-Flex Service Selector
  • 5.7 Provision the STPOPTS ANSIGFLEX Option
  • 5.8 Provisioning the GSMOPTS Options
  • 5.9 Provision the SCCP Service State and Point Codes
  • 5.10 Enable and Turn on the G-Flex MLR Feature
• 6 Measurements
  • 6.1 G-Flex Measurements
• 7 Maintenance
  • 7.1 G-Flex-Related Alarms
  • 7.2 G-Flex-Related UIMs
  • 7.3 Maintenance Commands
    • 7.3.1 rept-stat-sccp
  • 7.4 Debug Commands
  • 7.5 Status Reporting and Problem Identification
    • 7.5.1 EPAP Status and Alarm Reporting
    • 7.5.2 Hourly Maintenance Report