Configuring Local Media Playback - ACLI Only

Configuring local media playback with the ACLI-only configuration method differs slightly in terms of operational support, and is configured without SPL. Use the following procedure to configure playback on the Oracle® Enterprise Session Border Controller (E-SBC) realm using the 180-force trigger.

Although the procedure below sets parameters to a realm-config, you can apply the same parameters and values to a session-agent and a sip-interface.

1. In Superuser mode, use the following command sequence to access realm configuration:

   ORACLE# configuration terminal
   ORACLE(configure)# media-manager
   ORACLE(media-manager)# realm-config
   ORACLE(realm-config)# 

2. Set the ringback file.

   ORACLE(realm-config)# ringback-file my-media.wav

3. Set the ringback trigger.

   ORACLE(realm-config)# ringback-trigger 180-force

4. Use done and exit to complete the configuration.
5. Use save, verify-config and activate to apply the policy to the running configuration.

The verify-config command checks and reports on the following playback configuration issues:

• ringback-file refers to a file that exists under /code/media/
• ringback-file refers to a file that does not surpass the maximum size allowed 5 MB
• ringback-trigger and playbackConfig are not both configured