Set Up High Availability Mode
Use the following procedure to configure High Availability (HA) on a primary and secondary Oracle® Enterprise Session Border Controller (ESBC).
Confirm that you own an HA license.
In the following procedure, enter y to discard any changes and quit the installation wizard. The root prompt displays.
The wizard displays a warning stating that using the wizard can overwrite (erase) the existing running configuration. If you want to back out of the setup process and not overwrite the current running configuration, you can enter q or enter No at the Erase config and proceed prompt. The root prompt displays.
Note:
For HA environments, running setup on the secondary system is also required to set the wancom0 address and secondary targetname. The targetname must match the same secondary targetname specified on the primary system.To configure the primary ESBC for HA :
Run the Installation Wizard on the secondary peer of the HA pair.