Configure the Outbound TDM Policy

Time Division Multiplexing (TDM) operations require policies for directing traffic to and from the TDM realm. In the following procedure, you specify the attributes for outbound TDM traffic.

For the next-hop:tdm attribute, note that span and channel hops depend on the interface.

1. Access the local-policy configuration element.

   ORACLE# configure terminal
   ORACLE(configure)# session-router
   ORACLE(session-router)# local-policy
   ORACLE(local-policy)#

2. Set the following parameters.

   from-address	Set the origin address. Valid values: <ipv4> | <ipv6> | POTS Number | E.164 Number | hostname | wildcard
   to-address	Set the destination IP address. Valid values: <ipv4> | <ipv6> | POTS Number | E.164 Number | hostname | wildcard.
   source-realm	Set the source realm.
   description	Enter a description of the policy.
   state	Set state to enable. Valid values: enable | disable.
   policy-priority	Set the priority of the policy. Valid values: none | normal | urgent | non-urgent | emergency.
   policy-attributes	Set the following policy attributes: next hop. Set the next hop. Valid values: For the PRI and BRI interfaces—next-hop tdm:span:<number> For the Analog interface—next-hop tdm:channel:<number> next-hop tdm:group:<number> next-hop tdm:<profileName> realm: Set the realm for the next hop. action: Set the action to take. Valid values: none | redirect | replace-uri. Default: none. Do not set the replace-uri action when routing to a TDM interface. cost: Set the cost. Range: 0-999999999. Default: 0.

3. Type done to save your configuration.

• If your deployment requires an inbound TDM local policy, see "Configure the Inbound TDM Policy."