3.2.3 Procedure 3 PRE-UPGRADE HEALTH CHECK

Table 3-7 Procedure 3 PRE-UPGRADE HEALTH CHECK

STEP # A B This procedure determines the health of the MPS before beginning the Full upgrade. This procedure should be done 1 week before scheduled Full upgrade and repeated the day of the Full upgrade. Estimated time: 5 minutes

1.

☐

☐

MPS X:

Validate date, time and time zone to ensure accuracy.

# date

Fri May 20 07:05:41 EDT 2016

2.

☐

☐

MPS X:

Execute syscheck. 

# syscheck 
Running modules in class disk...  
                                 OK 
Running modules in class net...  
                                 OK 
Running modules in class proc...  
                                 OK Running modules in class system...  
                                 OK 
Running modules in class hardware...                                   OK 
The log is available at: 
  -->/opt/TKLCplat/log/syscheck/fail_log

3.

☐

☐

MPS X:

Check for any alarms on the server.

[elapdev@ E5APP-B-a ~]$ manageBannerInfo -l

There are currently no BannerInfo messages for this side in the database.

4.

☐

☐

MPS X:

Obtain the host id for logging purposes.

[elapdev@ E5APP-B-a ~]$ hostid a8c0b23d

5.

☐

☐

MPS X:

Obtain the uptime of the system for logging purposes.

[elapdev@ E5APP-B-a ~]$ uptime

03:29:12 up 46 days, 20:00, 5 users, load average:

0.16, 0.24, 0.27

6.

☐

☐

Repeat on the day of the scheduled Full upgrade

All Health Checks should be repeated the day of the Full upgrade. If any problems are encountered, resolve before proceeding further.

7.

☐

☐

MPS X: Note down the timestamp in log.

Run the following command.

$ date

This procedure is complete!