Known Issues

The following table lists the known issues in this release. You can reference known issues by Service Request ID number and you can identify the issue, any workaround, when the issue was found, and when it was fixed using this table. Issues not carried forward in this table from previous Release Notes are not relevant to this release. You can review delivery information, including defect fixes in the S-Cz10.0.0 Build Notes.

ID	Description	Severity	Found In
38756603	Insufficient free space in the /opt partition can cause failures during SFTP push operations and may result in system instability. This issue is specific to the /opt partition. Workaround: Monitor available space in the /opt partition regularly and periodically clean up unnecessary files to ensure adequate free space is maintained. If the system becomes unstable due to a full /opt partition, free up space and reboot the device.	3	S-Cz10.0.0p6
33600407	When you add IPv4 and IPv6 addresses consecutively on the hip-ip-list and icmp-address of the same network-interface, followed by save and activate, the system eventually activates the configuration change but the SBC goes into an unsteady state with the following events on the console: unregister_netdevice: waiting for <interface:id> to become free.Usage count = 1. Workaround: Add IPv4 and IPv6 address on the hip-ip-list and icmp-address separately and activate them individually. For example, activate the first config change or addition and then add and activate the second configuration change.	2	S-Cz8.4.0
32077115	For Hairpin and Spiral call scenarios, the hide-egress-media-update parameter under media-sec-policy is not supported. In addition, you must reboot the SBC when you change the hide-egress-media-update parameter under the media-sec-policy, inbound subelement. This parameter is not RTC supported. Oracle recommends you use the hide-egress-media-update parameter under the realm-config only.	3	S-Cz9.0.0
32565921	The acquire-config process is unsuccessful when your configuration includes an acp-tls-profile. The system does successfully synch the profile after establishing HA. Workaround: Disable your acp-tls-profile on the active system before performing an aquire-config procedure. Re-enable the profile after aquire-config completes successfully.	3	S-Cz9.0.0
26790731	Running commands with very long output, such as the "show support-info" command, over an OVM virtual console might cause the system to reboot. Workaround: You must run the "show support-info" command only over SSH.	2	S-Cz8.0.0
27699451	Oracle qualified the QSFP interface for the Session Router operating over the Oracle X9-2 platforms for a single QSFP port operating in 4-port mode. Specifically, 4 media interfaces successfully map to the second port of the QSFP interface using a Hydra cable as physical connections to 10G switch ports.	3	S-Cz8.1.0
30896106	The SBC dead peer detection does not work with IKEv1.	3	S-Cz8.4.0
28539190	When operating as a VNF and using Mellanox interface cards, the SBC does not use the Host In Path (HIP) configuration to restrict management traffic, Instead the system allows any traffic over the interface.	3	S-Cz8.2.0
30643522	Starting with S-Cz8.3.0m1p2, Lawful Intercept users cannot modify LI configuration with the Session Delivery Manager. Workaround: LI Configuration must be performed through the ACLI.	4	S-Cz8.3.0m1p2
34267143	No left-side Index and search in the browser for local Help files.	4	S-CZ9.1.0
39119235	In 10.0p7, when using push-receivers, the SBC creates empty directories for non-configured groups.	3	S-CZ10.0.0p7