1. Platform Preparation and Installation Guide
  2. Netra Server X5-2 Platform Preparation
  3. Cable the Netra X5-2 for Communications
  4. Connect ILOM to the Netra X5 for Communications

Connect ILOM to the Netra X5 for Communications

Use the following procedure to make a connection to the Netra X5-2 for Communications Oracle Integrated Lights Out Manager (ILOM) port. For a remote permanent connection to the Service Processor over the ILOM connection, use the rear panel NET MGT port.

Note:

Keep Ethernet cables separated from power cables by at least 60mm where possible and never run them in the same channel of the rack without segregation.
  • Category 6 (or better) Ethernet cable with RJ-45 jacks
  1. Locate the cable to connect to the Netra X5-2 for Communications.
  2. Plug the RJ-45 connector into the ILOM port.

    Figure 2-5 Connecting to ILOM Port

    This image displays the rear view of the X5-2 and labels the interface, per the image title.
  3. Lead the cable neatly away from the rear panel.
  4. Connect the other end of the cable to the LAN.
  • Refer to the Netra X5-2 for Communications hardware documentation for information on how to configure the Web browser application to connect to the console, and how to establish communications with the Netra X5-2 for Communications.