Configuring Local Media Playback - ACLI Only

Configuring local media playback with the ACLI-only configuration method differs slightly in terms of operational support, and is configured without SPL. Use the following procedure to configure playback on the Oracle Communications Session Border Controller (OCSBC) realm using the 180-force trigger.

Although the procedure below sets parameters to a realm-config, you can apply the same parameters and values to a session-agent and a sip-interface.

1. In Superuser mode, use the following command sequence to access realm configuration:

   ORACLE# configuration terminal
   ORACLE(configure)# media-manager
   ORACLE(media-manager)# realm-config
   ORACLE(realm-config)# 

2. Set the ringback file.

   ORACLE(realm-config)# ringback-file my-media.wav

3. Set the ringback trigger.

   ORACLE(realm-config)# ringback-trigger 180-force

4. Use done and exit to complete the configuration.
5. Use save, verify-config and activate to apply the policy to the running configuration.

The verify-config command checks and reports on the following playback configuration issues:

• ringback-file refers to a file that exists under /code/media/
• ringback-file refers to a file that does not surpass the maximum size allowed 5 MB
• ringback-trigger and playbackConfig are not both configured