fxo-profile
Use fxo-profile to add up to four Foreign Exchange Office (FXO) profiles to support different attributes at different endpoints. For example, you might create profiles based on username, department, or location.
Constraints
Only platforms with Digium analog cards support fxo-profile.
Path
The fxo-profile configuration element is in the tdm-config element.
ORACLE# configure terminal
ORACLE(configure)# system
ORACLE(system)# tdm-config
ORACLE(tdm-config)# fxo-profile
ORACLE(fxo-profile)#
Parameters
The fxo-profile configuration element contains the following parameters:
- name
-
Enter a name for this profile.
- channels
-
Enter the channels that apply to this profile. You can enter any combination of the four (5, 6, 7, 8) that apply to the FXO card.
- Default: 5,6,7,8
- rx-gain
-
Set the TDM receive volume in decibels.
- Default: 0.0
Valid value range is 0.0 - 9.9.
- tx-gain
-
Set the TDM transmit volume in decibels.
- Default: 0.0
Valid value range is 0.0 - 9.9.
- echo-cancellation
-
Enable or disable echo cancellation.
- Default: enabled
- Values: enabled | disabled
- fax-detect
-
Set the fax-detect.
- Default: both
- Values: incoming | outgoing | both | no
- route-group
-
Enter the number of the route-group for this profile.
- Default: 0
- Min: 0 | Max: 63
- signalling
-
Set the signaling type.
- Default: fxs_ks
- Values: fxs_ls | fxs_gs | fxs_ks
- phone-number
-
Enter the caller's number. Required.
- fullname
-
Enter the caller's name.
- cid-signalling
-
Set the caller ID signaling type.
- Default: bell
- Values: bell | v23
- options
-
Configure FXO options.