npli-profile
The npli-profile configuration element defines the system's behavior with respect to NPLI on the object to which it is applied.
Parameters
- name
- Configured name of this NPLI profile. This is the key field.
- Default: empty
- Values: 24 character string, no special characters with the exception of the underscore and hyphen characters. Do not start name with numeric character.
- add-ue-location-in-pani
- Enable this parameter to add UE Location string in the PANI
header when the location is available.
- Default: disabled
- Values: enabled | disabled
- hold-emergency-calls-for-loc-info
- Timer to hold emergency calls until the system receives location
information from the PCRF.
- Default: 0
- Values: 0-4294969295
- hold-invite-calls-for-loc-info
- The time the systems waits for the location information from the
PCRF in a RAR over the Rx interface, assuming it is greater than 0, and
reserve-incomplete is enabled.
- Default: 0
- Values: 0-4294969295
- cache-loc-info-expire
- Maximum number of seconds after which the system drops network
location information for the NPLI for the Short Message feature, unless the
keep-cached-loc-info-after-timeout
parameter is enabled.
- Default: 32
- Values: 1-4294967295 seconds
- msg-hold-for-loc-info
- Maximum number of seconds that the system holds MESSAGEs for
location information for the NPLI for the Short Message feature.
- Default: 0; disabled
- Values: 1-30 seconds
- npli-upon-register
- This adds the ability to capture Network Provided Location
Information during the Registration process.
- Default: disabled
- Values: enabled | disabled
- allow-pani-for-trusted-only
-
Allow PANI header only for trusted domains.
- Default: disabled
- Values enabled | disabled
- default-location-string-VoWifi
- Default location information string to be populated when no other
NPLI is provided and the AAA includes a RAT type of WLAN.
- Default: empty
- Values: 24 character string, no special characters with the exception of the underscore and hyphen characters. Do not start name with numeric character.
Path
npli-profile is an element in the session-config path. The full path from the topmost ACLI prompt is: .