radius-servers
Use the radius-servers configuration element to define and configure the RADIUS servers that the SBC communicates with.
Path
The radius-servers configuration element is in the authentication element.
ORACLE# configure terminal
ORACLE(configure)# security
ORACLE(security)# authentication
ORACLE(authentication)# radius-servers
ORACLE(radius-servers)#Parameters
The radius-servers configuration element contains the following parameters:
- address
-
Enter the IPv4 or IPv6 address of the RADIUS server.
- port
-
Enter the port number on the remote IP address for the RADIUS server.
- Default: 1812
- Valid value: 1645
- Valid value: 1812
- state
-
Enable or disable this configured RADIUS server
- Default: enabled
- Values: enabled | disabled
- secret
-
Enter the password the RADIUS server and the SBC share.
This password is not transmitted between the two when the request for authentication is initiated.
- nas-id
-
Enter the NAS ID for the RADIUS server.
- realm-id
-
Enter the RADIUS server realm ID.
- retry-limit
-
Set the number of times the SBC retries to authenticate with this RADIUS server.
- Default: 3
- Min: 1 | Max: 5
- retry-time
-
Enter the time in seconds the SBC waits before retrying to authenticate with this RADIUS server.
- Default: 5
- Min: 5 | Max: 10
- maximum-sessions
-
Enter the maximum number of sessions to maintain with this RADIUS server.
- Default: 255
- Min: 1 | Max: 255
- class
-
Select the class of this RADIUS server as either primary or secondary.
- Default: primary
- Values: primary | secondary
A connection to the primary server is tried before a connection to the secondary server is tried.
- dead-time
-
Set the time in seconds before the SBC retries a RADIUS server that it has designated as dead.
- Default: 10
- Min: 10 | Max: 10000
- authentication-methods
-
Select the authentication method the SBC uses when communicating with the RADIUS server.
- Default: all
- Values: all | chap | eap | mschapv2 | pap