fxs-profile
Use fxs-profile when your deployment requires a Foreign Exchange Service (FXS) profile for Time Division Multiplexing (TDM). You can add up to four FXS profiles to support different attributes at different endpoints. For example, you might create profiles based on user name, department, and location. Note that you must also configure tdm-config.
Constraints
Only platforms with Digium analog cards support fxs-profile.
Path
The fxs-profile configuration element is in the tdm-config element.
ORACLE# configure terminal
ORACLE(configure)# system
ORACLE(system)# tdm-config
ORACLE(tdm-config)# fxs-profile
ORACLE(fxs-profile)#
Parameters
The fxs-profile configuration element contains the following parameters:
- name
-
Enter the fxs profile name.
- channels
-
Enter the channels that apply to this profile. You can enter any combination of the four (1, 2, 3, 4) that apply to the FXS card.
- Default: 1,2,3,4
- rx-gain
-
Set the TDM receive volume in decibels.
- Default: 0.0
- Values: 0.0 - 9.9
- tx-gain
-
Set the TDM transmit volume in decibels.
- Default: 0.0
- Values: 0.0 - 9.9
- echo-cancellation
-
Enable or disable echo cancellation.
- Default: enabled
- Values: enabled | disabled
- fax-detect
-
Set the fax-detect.
- Default: both
- Values: incoming | outgoing | both | no
- route-group
-
Enter the number of the route-group for this profile.
- Default: 0
- Min: 0 | Max: 63
- signalling
-
Set the signaling type.
- Default: fxo_ks
- Values: fxo_ls | fxo_gs | fxo_ks
- phone-number
-
The caller's number.
- fullname
-
The caller's name.
- cid-signalling
-
Set the caller ID signaling type.
- Default: bell
- Values: bell | v23
- options
-
Configure additional FXS options.
- voice-codec
- Set the voice codec.
This attribute is only available on platforms that have the Wanpipe driver installed.
- Default: MULAW
- Values: MULAW | ALAW