2.7.6.1 Trigger Installation

This section describes how to trigger installation.

For installation, you can pass argument '-i' or '--install'.

To run the Compliance Studio installer:

1. Navigate to the <COMPLIANCE_STUDIO_INSTALLATION_PATH>/bin directory.
2. Run the following command with a Linux user where Compliance Studio is installed:
   ./compliance-studio.sh –i
   Or
   ./compliance-studio.sh --install

   This will copy the whole compliance studio into the folder 'deployed' and then replaces the placeholders. Now, you can start Compliance Studio.

   Note:

   • Run these commands only from <COMPLIANCE_STUDIO_INSTALLATION_PATH>/bin.
   • It should not be run from <COMPLIANCE_STUDIO_INSTALLATION_PATH>/deployed/ bin.
   • Upon executing the ./compliance-studio.sh –i command.A deployed folder is created that copies all the folders. And replaces placeholders inside the deployed folder.
   Congratulations! Your installation is complete.

   Note:

   For any help on installation commands, Run ./compliance-studio.sh --help
3. To verify the installed patch version(s) of Compliance Studio, users can check this FCC_COMPLIANCE_STUDIO_PATCHES table in the Studio Schema.