9.6.2 Editing Additionally Added Processes and Models in Composite Pipeline

You can edit (add or remove) only the newly added processes and models from the composite pipeline. You cannot edit the process or models that are added automatically through the selected variables and models in the previous steps of analysis configuration creation wizard. Also, you cannot modify anything in the runs, subruns, and scenarios that are part of the composite pipeline.

1. Login to STSA.
   The Workspace Summary page is displayed.
2. In the Workspace Summary, Sandbox tab, launch the required workspace.
3. Click Analysis Configuration.
   The analysis configuration summary page is displayed.
4. To open the specific analysis configuration, click the analysis configuration or click More Actions on the required configuration and click View.
   The Review & Validate screen is displayed.
5. Click Process on the right-hand side.

   The Process page and the selected composite pipeline is displayed.

6. Click actions against the pipeline and click Edit.
   The Process Pipeline page is displayed.
7. To add new processes, click the Add New Processes tab.
   Based on your previous selection, all the applicable processes are listed.
8. Select the required processes and click Add.
   A pop-up message is displayed for auto-sequencing option.

   • If you want to continue with auto-sequencing, click Yes.

     If you select the auto-sequencing option, a confirmation message is displayed. Click OK and proceed to the Process Pipeline page.

   • If you want to continue with manual sequence, click No.

     For more information on sequencing the runs, see the Sequencing Runs.

9. To save the changes, click OK and then click Save and Close.