Note: In DMS Status values, A means Automatic and M means Manual.
Interpreting EVR Progress
 
DMS Status
Meaning
Operator Action
EVR (A/M) Event Created
The event and EVR solution have been created.
Open the EVR Report and confirm the request and solution details.
EVR (A/M) Sheet Created
EVR created or associated a switching sheet with the event.
Open the sheet and verify the generated device blocks and values.
EVR (A/M) Sheet Scheduled
The switching sheet is queued for its scheduled execution time.
Verify Scheduled Time, Start Date, End Date, and device blocks.
EVR (A/M) Sheet Executing
One or more EVR switching steps are in progress.
Monitor step results and avoid conflicting device operations.
EVR (A/M) Completed
The requested EVR execution work reached a completed state.
Verify actual setpoint, bandwidth, and low-limit values using current SCADA information.
EVR (A/M) Execution Failed
The EVR execution did not complete normally.
Identify completed steps, verify actual device state, and determine corrective or restore work.
Understanding EVR Switching Sheets
An EVR switching sheet contains generated device-control steps and is associated with the EVR event. Device blocks can contain operations to set the bandwidth, low limit, and setpoint. Scheduled sheets also display Scheduled Time values.
Before execution or when reviewing completed work, verify the following:
• The number of device blocks is consistent with the executable rows in the EVR solution.
• Each block identifies the intended device and active phases.
• The generated values match the reviewed target, bandwidth, and low-limit values.
• The displayed order of bandwidth, low-limit, and setpoint operations is appropriate.
• Scheduled Time values are present and correct for scheduled blocks.
• The reason for each failed, skipped, or previously completed step is understood before additional work is generated.
Verifying EVR Execution
A completed event or sheet confirms workflow completion, but you should also verify the actual device state. Use current SCADA information, device details, and the switching sheet to confirm the applied values.
• Compare actual setpoint, bandwidth, and low-limit values with the EVR solution.
• Confirm that all intended devices and phases participated.
• Identify devices that did not respond or that completed only part of a device block.
• Record any manual correction or restoration required by local operating procedures.
Using the EVR Report
Opening the EVR Report
1. Open the EVR event in Event Details.
2. Select the EVR Report tab.
3. Review the Messages tab.
4. Review the Solution Summary tab and compare it with the generated sheet.
Reviewing EVR Messages
The Messages table records the time, alarm indicator, and message description for major actions in the EVR life cycle. The displayed message text provides an auditable record of the EVR request, calculation, sheet creation, execution, and restoration activity.
 
Displayed Message Example
What It Confirms
Operator Review
EVR event [event] created for solution [solution].
An EVR event was created for the associated solution.
Verify the event and solution identifiers.
EVR request for solution ...
The reduction percentage, device category, execution mode, and restore mode were recorded.
Confirm they match the approved request.
EVR target calculation summary for solution ...
The report recorded counts such as ready, override, disabled, missing SCADA, and blocked.
Confirm that the reason for each abnormal or excluded result is understood.
Started EVR switching sheet creation ...
EVR began switching-sheet generation.
Use the following messages to confirm completion.
Completed EVR switching sheet ...
EVR completed sheet creation and recorded the sheet identifier.
Open and review the generated sheet.
EVR switching sheet ... submitted for immediate execution.
The sheet was submitted for immediate execution.
Confirm that immediate execution was intended.
Execution and restore messages
The report records later execution or restore activity.
Investigate alarm rows, failures, partial results, or unexpected timing.