TRAILCHARSET
Valid For
Replicat
Description
Note:
This parameter has been replaced by the SOURCECHARSET
parameter but may still be retained in existing parameter files for backward compatibility.
Use the
TRAILCHARSET
parameter to supply a character set for the source
data if the trail is written by an Extract version that is earlier than 11.2.1.0.0.
In the earlier versions, the source character set is not stored in the trail.
When TRAILCHARSET
is used, Replicat uses the specified character set as the source character set when converting character-type columns to the target character set. Replicat issues a warning message when it uses the TRAILCHARSET
character set.
By default, Replicat performs character set conversion. This feature is controlled by the CHARSETCONVERSION
(default) and NOCHARSETCONVERSION
parameters. To use TRAILCHARSET
, NOCHARSETCONVERSION
cannot be used.
Default
Character set of the operating system
Syntax
TRAILCHARSET source_charset [, REPLACEBADCHAR];
-
source_charset
-
The ICU character-set identifier or an Oracle character-set identifier of the source database. For Oracle databases, Oracle GoldenGate converts an Oracle identifier to the corresponding ICU identifier for conversion to the character set that is specified with the
NLS_LANG
specification in theSETENV
parameter in the Replicat parameter file. -
REPLACEBADCHAR
-
Prevents Replicat from abending when a conversion attempt fails. The failed character is replaced with a replacement character for each target character set. The replacement character is pre-defined in each character set.