Administration Console Online Help

Previous Next Open TOC in new window
Content starts here

Configure thread dump action

Before you begin

Create diagnostic system modules

Create thread dump action

To edit a task help topic that fulfills the minimal requirements:

  1. If you have not already done so, in the Change Center of the Administration Console, click Lock & Edit (see Use the Change Center).
  2. In the left pane of the Console, select Diagnostics > Diagnostic Modules.
  3. In the Diagnostic System Modules table, select the name of the diagnostic system module containing the thread dump action you want to configure.
  4. Select Configuration > Policies and Actions > Actions.
  5. In the Actions table, select the name of the thread dump action you want to configure.
  6. On the Thread Dump Properties page:
    1. In Timeout (in seconds), enter the interval of time length of time, in seconds, that this action has to complete execution. The value you enter must be greater than the number of thread dumps multipled by the value entered in Delays (in seconds). A value of 0 indicates timeout disabled..
    2. In Number of thread dumps, enter the number of thread dumps that you want this action to capture.
    3. In Delays (in seconds), enter the delay, in seconds, to pause betweeen thread dumps captured by this action.
  7. Click Save.
  8. In the Change Center, click Activate Changes.

Back to Top