HBA Features

The Oracle Storage 12 Gb SAS PCIe RAID HBA, Internal: 16 Port and 2 GB Memory (part number: 7116970) is a low-profile, PCI Express 3.0 RAID controller that supports 16 internal 12 Gb/s SAS connectors through four internal mini-SAS HD ports. The 16 connectors on the board enable direct connection to all internal drives, and eliminate the need for a SAS expander. Data that is cached on the HBA is protected, in the event of a power failure.

Table 1-1 HBA Features

Feature Description

Ports

Four SAS3, x4 internal mini-SAS HD ports, 16 total phys

Host interface

PCIe, as defined in the PCI Express Card Specification, version 3.0

Target interface

SAS3 12-Gb/s

Lane width

PCIe 3.0 x8 lane width up to 8 Gt/s per lane

Performance

High, through the MegaRAID Firmware Interface (MFI) architecture

Throughput

High throughput and low CPU utilization to offload the host processor

Boot support

For all supported operating systems (OSs) (see Operating System and Technology Requirements)

Power consumption

Maximum 25 Watts

Diagnostic support

Provided by Oracle VTS

Oracle Solaris Dynamic Reconfiguration

Supported

PCIe Single Root I/O Virtualization (SR-IOV)

Supported

MSI-X

Supported

PCIe hot-plug and hot-swap capabilities

Supported

RAID

  • Full-featured, hardware-based RAID implementation

  • A RAID on CHIP (ROC) controller, supporting a hardware RAID acceleration engine with a capacity of 2 GB, DDR-3 cache memory, and power fail backup support

  • Integrated SAS/SMP/STP/SSP protocol support

  • 12 Gb/s SAS interface supporting 6 and 3 Gb/s SAS

  • Data striping across multiple drives

  • Data mirroring or parity block for backing up data

  • Support for RAID levels 0, 1, 5, 6, 10, 50, and 60, with 2 GB data cache, and with accelerated XOR on RAID 5 and 6

  • Built-in flash controller for direct flash backup from DDR memory

  • User-configurable rebuild rate