How to Install NTP After Adding a Node to a Single-Node Cluster

When you add a node to a single-node cluster, you must ensure that the NTP configuration file that you use is copied to the original cluster node as well as to the new node.

Assume the root role on a cluster node.
Copy the /etc/inet/ntp.conf and /etc/inet/ntp.conf.sc files from the added node to the original cluster node.

These files were created on the added node when it was configured with the cluster.
On the original cluster node, create a symbolic link named /etc/inet/ntp.conf.include that points to the /etc/inet/ntp.conf.sc file.
```
phys-schost# ln -s /etc/inet/ntp.conf.sc /etc/inet/ntp.conf.include
```
On each node, determine the state of the NTP service.
```
phys-schost# svcs svc:/network/ntp:default
```
Start the NTP daemon on each node.
- If the NTP service is disabled, enable the service.
```
phys-schost# svcadm enable svc:/network/ntp:default
```
- If the NTP service is online, restart the service.
```
phys-schost# svcadm restart svc:/network/ntp:default
```

Next Steps

Determine from the following list the next task to perform that applies to your cluster configuration. If you need to perform more than one task from this list, go to the first of those tasks in this list.

If you want to create cluster file systems, go to How to Create UFS Cluster File Systems.
To find out how to install third-party applications, register resource types, set up resource groups, and configure data services, see the documentation that is supplied with the application software and the Planning and Administering Data Services for Oracle Solaris Cluster 4.4.
When your cluster is fully configured, validate the configuration. Go to How to Validate the Cluster.
Before you put the cluster into production, make a baseline recording of the cluster configuration for future diagnostic purposes. Go to How to Record Diagnostic Data of the Cluster Configuration.