maxusers
Parameter
- Description
-
Originally,
maxusers
defined the number of logged in users the system could support. When a kernel was generated, various tables were sized based on this setting. Current Oracle Solaris releases do much of its sizing based on the amount of memory on the system. Thus, much of the past use ofmaxusers
has changed. The following list identifies subsystems that are still derived frommaxusers
:-
The maximum number of processes on the system
-
The number of quota structures held in the system
-
The size of the directory name look-up cache (DNLC)
-
- Data Type
-
Signed integer
- Default
-
Lesser of the amount of memory in MB or 2048, and the greater of that value and nCPUs x 8
- Range
-
1 to the greater of 2048 or nCPUs x 8, based on the size of physical memory, if not set in
/etc/system.d/file
1 to the greater of 4096 or the nCPUs x 8, if set in
/etc/system.d/file
- Units
-
Users
- Dynamic?
-
No. After computation of dependent parameters is done,
maxusers
is never referenced again. - Validation
-
If the value is greater than the maximum allowed, it is reset to the maximum. A message to that effect is displayed.
- When to Change
-
When the default number of user processes derived by the system is too low. This situation is evident when the following message displays on the system console:
out of processes
You might also change this parameter when the default number of processes is too high, as in these situations:
-
Database servers that have a lot of memory and relatively few running processes can save system memory when the default value of
maxusers
is reduced. -
If file servers have a lot of memory and few running processes, you might reduce this value. However, you should explicitly set the size of the DNLC. See ncsize Parameter.
-
- Commitment Level
-
Unstable