fwupdate Error Codes
The following table lists the fwupdate
command error codes.
You can also list the error codes using the fwupdate
list error-codes
command. See list Subcommand Overview for more information.
Code Number | Error Description |
---|---|
200 |
Invalid device type. |
201 |
Invalid device target type.. |
202 |
Invalid device ID, please run \"fwupdate list all\" to verify id. |
203 |
Reset of component failed. |
204 |
Firmware check failed for component. |
205 |
Firmware download failed for component. |
206 |
Specified component and specified image type do not match. |
207 |
Must specify an image file name when doing an update. |
208 |
Could not read specified image file. |
209 |
Reset of this component type is not supported. |
210 |
Specified component type does not match devices type. |
211 |
Must specify device to update. |
212 |
Update canceled by user. |
213 |
Firmware version information not available. Reset necessary to activate new firmware. |
214 |
Version verification failed. |
215 |
Final version is being reported the same as the starting version. Update may have succeeded, please check update documentation. |
216 |
Missing or corrupt firmware file referenced by firmware metadata file. |
217 |
Metadata file invalid or corrupt. |
218 |
Metadata error. Prerequisite and priority settings conflict. |
219 |
Power control option is not supported for pre-application. |
220 |
Power control option is not supported for post-application. |
221 |
Power Control option is not supported. |
222 |
Requested component not available. |
223 |
Can't verify version information, no XML provided. |
224 |
Metadata does not include support for this host. |
225 |
Could not identify host type. |
226 |
A valid subcommand required. |
227 |
Invalid option entered. |
228 |
Must specify device to reset. |
229 |
Cannot open file to write XML output. |
230 |
Metadata XML file is required. |
231 |
Invalid priority level entered. |
232 |
Cannot read firmware metadata XML file. |
233 |
Missing required command argument. |
234 |
SP has not recovered in the allotted time limit after an update. The default time for the SP to recover after an update is 15 minutes or a value specified in the metadata XML file. |
235 |
Update forced failure due to a configuration error in the metadata XML file. |
236 |
Oracle ILOM backup image feature is not supported on the target service processor. |
254 |
Thread management failure. |
Parent topic: CLI Tools Error Codes