raidconfig Error Codes

Errors might be returned if you attempt to configure the RAID entry for an unsupported parameter. For example, if the RAID controller does not support the configured RAID level, the CLI displays a user-friendly error string identifying the misconfiguration and returns a matching error code.

The following table lists the error codes and strings specific to this tool.

Code Number	Error Description
100	No controllers available.
101	Controller does not support RAID.
102	No physical disks associated with controller.
103	Invalid controller.
104	Invalid disk.
105	Invalid RAID volume.
106	RAID level not supported by controller.
107	Default RAID level not supported.
108	A defined disk is in use.
109	Number of disks exceeds allowed number for this level.
110	Failure retrieving internal data.
111	Number of disks requested exceeds the number of available disks.
112	Cannot define both actual and requested number of disks.
113	Option not supported by controller.
114	Invalid stripe size for controller.
115	Invalid number of subarrays.
116	Cannot retrieve RAID data.
118	RAID creation failure.
119	RAID deletion failure.
120	Disk defined multiple times.
121	Disks must be in the same controller.
122	The maximum number of RAID Volumes has been created.
123	Invalid RAID configuration.
124	The RAID Volume is in use.
125	Incomplete RAID configuration.
126	Failure writing internal data.
127	Command requires disks to be entered.
128	Disk is not a dedicated spare.
129	Disk is not a global spare.
130	Controller does not support dedicated spares.
131	Controller does not support global spares.
132	Command requires disks or RAID volume to be entered.
133	A defined disk is not in a RAID volume.
134	Cannot set both read and write cache in same command.
135	Import could not create RAID volumes or spares - disks may be in use.
136	Subarrays option is required for this RAID level.
137	Incomplete command, no options have been supplied.
138	Number of disks requested exceeds the number of available disks with the same capacity.
139	RAID configuration does not have enough disks for the requested RAID level.
140	RAID configuration has too many disks for the requested RAID level.
141	Disk detected as in use by another controller. Use raidconfig restore or clear command.
142	The number of spares exceeds the maximum allowed by controller.
143	This command does not support the number-disks option.
144	Task type is invalid.
145	Task type must be defined.
146	Task type is only valid for disks.
147	Task type is only valid for RAID Volumes.
148	For this task, disk must not be in use.
149	For this task, disk must be in a RAID Volume.
150	Command currently cannot be executed.
151	The source disk must be in a RAID Volume.
152	The destination disk must not be in a RAID Volume.
153	The source and destination cannot be the same disk.
154	The source and destination are not the same size.
155	No foreign configuration detected for controller.
156	Unable to add disk to RAID Volume.
157	Task cannot be started, make sure task is listed in Startable Tasks.
158	Task cannot be stopped, make sure task is listed in Stoppable Tasks.
159	Invalid command, filename must come before options.
160	All disks must be the same size.
161	Command is not valid for this RAID level.
162	Subdisk sizes must be less than disk capacity.
163	Could not restore controller configuration.
164	The maximum number of subdisks is 16.
165	Invalid configuration, make sure spare is same size as disks in RAID Volume.
166	Disk mode is set to JBOD. Disable JBOD mode then try again.
167	Disk is in use by RAID controller. Remove from RAID configuration then try again.