- Oracle ILOM Protocol Management Reference SNMP and IPMI Firmware Release 5.0.x
- SNMP Overview
- SNMP Command-Line Syntax Examples
- Configure the SNMP Network Environment
Configure the SNMP Network Environment
-
Log in the Oracle ILOM command-line
interface (CLI).
For instructions on logging in to Oracle ILOM, refer to the Log In to the Oracle ILOM CLI.
-
In Oracle ILOM, issue the create command to create an SNMP Community Name.
-> create /SP/services/snmp/communities/community name
- Issue the
set
command to enable SNMP access and specify the SNMP agent port address, for example:->
set /SP/services/snmp servicestate=enabled v3=enabled port=161
- Download the Oracle ILOM MIBs to the
$HOME/mibs
directory.For instructions on downloading the Oracle ILOM MIBs, see Downloading SNMP MIBs Using Oracle ILOM.
-
In the
$HOME/.snmp/snmp.conf file in
the $HOME/mibs directory,
specify the following:
In the
$HOME/.snmp/snmp.conf
file in the$HOME/mibs
directory, specify the following:defversion 3 defcommunity community_name defaultPort 161 mibs ALL mibdirs +$HOME/mibs
-
Test the new configuration by issuing the
following command:
%snmp SNMP_agent sysName.0
The command should produce similar output on your system:
RFC1213-MIB::sysName.0 = STRING: “systemname”